Single Watch Winder - Aviation aluminum Blue

Operation

First, wind the stopped or insufficient mechanical watch manually or wear it for more than 2 hours, so that the watch has a certain amount of kinetic energy, and then follow the steps below:

• Open the product cover, take out the watch pillow, and fix the watch on the watch pillow.
• Put the watch pillow back to the winding watch position to ensure that the watch is securely fixed.
• Plug in the power adapter of the product, turn on the power switch, and select the appropriate gear switch to use.

Features

• Mode1: OFF;
• Mode2: Clockwise for 2 minutes and stop for 6 minutes, loop;
• Mode3: Counterclockwise rotation for 2 minutes, stop for 6 minutes, loop;
• Mode4: Clockwise rotation for 1 minute, counterclockwise rotation for 1 minute, stop for 6 minutes, loop.

Important Notes

• Please do not manually spin the winder because it will damage your watch winder.
• Please remove the power adapter when the watch winder is not used for a long time.
• Please turn off the watch winder before inserting or removing the watch.
• Please DO NOT block the rotator when the watch winder is moving.
• Keep children under 8 years of age away from the watch winder and power cables. Children shall not play with the units.
• Keep the watch winder away from the high magnetic object.
• Do not place the product under the sun or humid places.
• Specifications subject to change without notice in accordance with our policy of continuous product improvement.

Maintenance and Care

• Use a microfiber cloth or lint-free cloth to clean the watch winder surface with circular movements. Do NOT placing your winder in direct sunlight.
• Clean the interior regularly with a brush by brushing in the direction of the grain. DO NOT use vacuum cleaners or anywet cleaning tools.
• The motor and electronic pats do not require any maintenanceto ensure the fault-free functions.

Troubleshooting

There are some factors which generally affect the effectiveness of the winder:

• Check the watch placement in the winder, Your watch should be placed with the dial facing up in the winder.
• Some watches must be fully wound before place into our winder as the power reserve may not be enough to keep the watch wound when removed from your wrist. Please refer to your instruction manual on how to manually wind your watch.
• Please wind your watch manually before placing it into the winder, In some cases, due to the watch design, a steeper winding angle is required .You can prop the back of winder using a book or magazine to increase the angle of the turntable then test the wind again. The vertical the better the chance of the test being accurate.